DTC P1713 - Transmission Oil Temperature Above Maximum Threshold
Conditions for setting dtc P1713
| ￭ | Engine Running |
| ￭ | Transmission Oil Temperature Sensor ≥ 302 °F |
| ￭ | The above must be present for a period of 128 instances/cycles or greater to trigger DTC P1713 |
|
Step |
Action |
Value (s) |
YES |
NO |
|
1 |
- Key on, Engine running - Within VCM Live, open the Trans Temp sensor DTC Maximum parameter, does the Trans Temp sensor parameter display 302 °F or greater? |
≥ 302 °F |
Go to Step 2 |
Intermittent Issue (Refer to Intermittent Diagnostics) |
|
2 |
- Disconnect the trans Oil Temp sensor connector and the sub harness connector - With a DVOM check for continuity between the trans fluid temp signal pin 1 & cavity "L" |
|
Go to Step 3 |
Repair the circuit as necessary, locate any wires that need to be repaired or replaced |
|
3 |
- Disconnect the trans Oil Temp sensor connector and the sub harness connector - With a DVOM check for continuity between the trans fluid temp low reference pin 12 & cavity "M" |
|
Go to Step 4 |
Repair the circuit as necessary, locate any wires that need to be repaired or replaced |
|
4 |
- Inspect the Trans Temp Sensor connector and pins for corrosion, contamination or any physical damage. - Any issues found? |
|
Repair any issues found and retest. |
Go to Step 5 |
|
5 |
- Replace the Trans Temp Sensor - Is the replacement complete? |
|
Go to Step 6 |
N/A |
|
6 |
- Clear any DTC from the ECU - Turn the ignition off and wait 30 seconds - Start the engine and operate the engine to full operating temperature - Observe the Check Engine Light on the Menu bar in VCM Live - After operating the engine within the test parameters, check for any store codes - Does the engine operate without any stored DTC's? |
|
System is now operational and ready to be tuned |
Contact HP Tuners Support |
Table 43. Tranmission Oil Temperature Above Maximum Threshold Diagnostics Table
NOTE: Reference DTC P1843 - Transmission Line Pressure Above Maximum Threshold for sensor cavity location.
