DTC P1107 - Manifold Absolute Pressure Below Minimum Threshold
Conditions for setting dtc P1107
| ￭ | Engine Running |
| ￭ | Manifold Absolute Pressure Sensor ≤ 0.73 psi |
| ￭ | The above must be present for a period of 128 instances/cycles or greater to trigger DTC P1107 |
|
Step |
Action |
Value (s) |
YES |
NO |
|
1 |
- Key ON, Engine Running at full operating temperature - Within VCM Live, open the MAP sensor DTC Minimum parameter, does the MAP sensor parameter display 0.73 psi or less? |
≤ 0.73 psi |
Go to Step 2 |
Intermittent Issue (Refer to Intermittent Diagnostics) |
|
2 |
- Key OFF - Disconnect the MAP sensor connector - Key ON - Does the MAP sensor parameter within VCM Live display less than 0.5 psi? |
≤ 0.5 psi |
Go to Step 3 |
Go to Step 5 |
|
3 |
- Probe the MAP ground connector cavity "A" (for Drive-By-Cable harness) cavity 2 (for Drive-By-Wire harness) with a test light connected to battery voltage - Does the test light come on? |
|
Go to Step 4 |
Go to Step 6 |
|
4 |
- Check the MAP mechanical vacuum connection for correct mounting or any possible physical damage that may cause leakage - Any issues found? |
|
Go to Step 5 |
Repair any issues found |
|
5 |
- Key OFF - Disconnect the ECU connector "C" and inspect the terminals for any physical damage or corrosion and contamination - Any issues found? |
|
Go to Step 6 |
Repair the pins as necessary and circuit. |
|
6 |
- Replace the MAP sensor - Is the repair complete? |
|
Go to Step 7 |
N/A |
|
7 |
- Clear any DTC from the ECU - Turn the ignition off and wait 30 seconds - Start the engine and operate the engine to full operating temperature - Observe the Check Engine Light on the Menu bar in VCM Live - After operating the engine within the test parameters, check for any store codes - Does the engine operate without any stored DTC's? |
|
System is now operational and ready to be tuned |
Contact HP Tuners Support |
Table 30. Manifold Absolute Pressure Below Minimum Threshold Diagnostics Table
NOTE: Reference DTC P0108 - Manifold Absolute Pressure Sensor Circuit High for sensor cavity location.
