DTC P0522 - Oil Pressure Sensor Circuit Low
Conditions for setting dtc P0522
| ￭ | Engine Running |
| ￭ | Oil Pressure Sensor ≤ 0.1 volts |
| ￭ | The above must be present for a period of 128 instances/cycles or greater to trigger DTC P0522 |
|
Step |
Action |
Value (s) |
YES |
NO |
|
1 |
- Key on, Engine running - Within VCM Live, open the Oil Pressure sensor DTC parameter, does the Oil Pressure sensor parameter display 0.1 volts or less? |
≤ 0.1 volts |
Go to Step 2 |
Intermittent Issue (Refer to Intermittent Diagnostics) |
|
2 |
- Key OFF - Disconnect the Oil Pressure sensor connector & the Oil Pressure sensor ECU connector "C" - Using a DVOM check for continuity between the oil pressure sensor signal connector cavity 3 (for Drive-By-Cable harness) cavity 1 (for Drive-By-Wire Harness) & the ECU connector "C" pin 19 (for Drive-By-Cable harness & Drive-By-Wire harnesses) - Do you have continuity between them? |
|
Go to Step 3 |
Repair the circuit as necessary, locate any wires that need to be repaired or replaced |
|
3 |
- Key OFF - Disconnect the Oil Pressure sensor connector & the Oil Pressure sensor ECU connector "C" - Using a DVOM check for continuity between the oil pressure sensor 5 volt reference connector cavity 2 (for Drive-By-Cable harness & Drive-By-Wire harnesses) & the ECU 5v C18-2 (for Drive-By-Cable harness) & C41-2 (Drive-By-Wire harnesses) - Do you have continuity between them? |
|
Go to Step 4 |
Repair the circuit as necessary, locate any wires that need to be repaired or replaced |
|
4 |
- Key OFF - Disconnect the Oil Pressure sensor connector & the Oil Pressure sensor ECU connector "C" - Using a DVOM check for continuity between the oil pressure sensor low reference connector cavity 1 (for Drive-By-Cable harness) cavity 3 (for Drive-By-Wire Harness) & the ECU connector "C" pin SP3 (for Drive-By-Cable harness & Drive-By-Wire harnesses) - Do you have continuity between them? |
|
Go to Step 5 |
Repair the circuit as necessary, locate any wires that need to be repaired or replaced |
|
5 |
- Replace Oil Pressure Sensor - Is the replacement complete? |
|
Go to Step 6 |
N/A |
|
6 |
- Clear any DTC from the ECU - Turn the ignition off and wait 30 seconds - Start the engine and operate the engine to full operating temperature - Observe the Check Engine Light on the Menu bar in VCM Live - After operating the engine within the test parameters, check for any store codes - Does the engine operate without any stored DTC's? |
|
System is now operational and ready to be tuned |
Contact HP Tuners Support |
Table 24. Oil Pressure Sensor Circuit Low Diagnostics Table
