DTC P1362 - Fuel Pressure Below Minimum Threshold
Conditions for setting dtc P1362
| ￭ | Engine Running |
| ￭ | Fuel Pressure Sensor ≤ 0.0 psi |
| ￭ | The above must be present for a period of 128 instances/cycles or greater to trigger DTC P1362 |
|
Step |
Action |
Value (s) |
YES |
NO |
|
1 |
- Key ON, Engine Running - Within VCM Live, open the Fuel Pressure sensor DTC Minimum parameter, does the Fuel Pressure sensor parameter display 0.0 psi or less? |
≤ 0.0 psi |
Go to Step 2 |
Intermittent Issue (Refer to Intermittent Diagnostics) |
|
2 |
- Check the fuel pressure using a manual fuel pressure gauge - Does the manual fuel pressure gauge read 0.0 psi or less? |
≤ 0.0 psi |
Go to Step 3 |
Go to Step 4 |
|
3 |
- Check the fuel pressure hoses for proper installation, routing, and blockages - Any issues found? |
|
Repair the hoses as necessary |
Go to Stop 4 |
|
4 |
- Replace the fuel pressure sensor - Is the replacement complete? |
|
Go to Step 5 |
N/A |
|
5 |
- Clear any DTC from the ECU - Turn the ignition off and wait 30 seconds - Start the engine and operate the engine to full operating temperature - Observe the Check Engine Light on the Menu bar in VCM Live - After operating the engine within the test parameters, check for any store codes - Does the engine operate without any stored DTC's? |
|
System is now operational and ready to be tuned |
Contact HP Tuners Support |
Table 38. Fuel Pressure Below Minimum Threshold Diagnostics Table
