DTC P0130 - Lambda Bank 1 Sensor 1 Circuit Failure
Conditions for setting dtc P0130
| ￭ | Engine Running |
| ￭ | Lambda Bank 1 Sensor 1 open circuit detected for heater |
| ￭ | The above must be present for a period of 128 instances/cycles or greater to trigger DTC P0130 |
|
Step |
Action |
Values (s) |
YES |
NO |
|
1 |
- Key OFF - Disconnect the lambda 1 sensor and ECU connector "C" - Check for continuity lambda 1 sensor connector cavity 3 and ECU connector "C" pin 18 - Do you have continuity? |
|
Go to Step 2 |
Repair the circuit as necessary, locate any wires that need to be repaired or replaced |
|
2 |
- Key OFF - Disconnect the ECU connector "C" and inspect pin 18 for any corrosion and contamination - Any issues found |
|
Repair the circuit as necessary and fix any pins with corrosion or contamination |
Go to Step 3 |
|
3 |
- Replace lambda bank 1 |
|
Go to Step 4 |
N/A |
|
4 |
- Clear any DTC from the ECU - Turn the ignition off and wait 30 seconds - Start the engine and operate the engine to full operating temperature - Observe the Check Engine Light on the Menu bar in VCM Live - After operating the engine within the test parameters, check for any store codes - Does the engine operate without any stored DTC's? |
|
System is now operational and ready to be tuned |
Contact HP Tuners Support |
Table 11. Lambda Bank 1 Sensor 1 Circuit Failure Diagnostics Table
