How do you delete the CAGS on a M6 '03 C5?
And if I have High Flow 3" Randam Tech Cats (Metal Matrix); do I have to delete my rear bank O2's???
How?
How do you delete the CAGS on a M6 '03 C5?
And if I have High Flow 3" Randam Tech Cats (Metal Matrix); do I have to delete my rear bank O2's???
How?
from the help files:
The parameters control the Computer Aided Gear Selection (CAGS or “Skip Shift”) feature of the VCM. It engergises a solenoid in the transmission to force shifting to 4th gear under light throttle conditions. If disable TPS is exceeded then the solenoid will not energise.
Disable %TPS: Throttle Position to disable C.A.G.S. routine
Enable Speed: Speed to enable C.A.G.S. routine
Disable Speed: Speed to disable C.A.G.S. routine
Enable Baro: Baro to enable C.A.G.S. routine
Disable Baro: Baro to disable C.A.G.S. routine
Min Coolant Temp: Minimum Engine Coolant Temp required for C.A.G.S. routine
I count sheep in hex...
How about the High Flow Cats Bypass o2's or ???
How?????
Might as well leave the rear tests be, unless the cats
are so ineffective they trip an efficiency fault. But they
should stay different enough from fronts that no delete
/ disable is required.
I have the Jet Hot catted Y pipe, and it sets off my service engine light.
So I'd be interested in how to "delete" the rear o2s.
2002 Trans Am 6sp, Hurst shifter, short stick,
!skip shift, SLP lid, Holley filter, Dynomax Ultraflow muffler, Jet Hot long tubes and cats, FRA, HP tuners, Hotchkis STB and LCAs. TEA stage 1.5 5.3 heads, Comp 220/224 114 +2, UMI Boxed SFCs
engine diagnostics,DTC's, all dtc that have to do with "O2 sensor 2" SES disabled, 3 no error reported.
I did this and still got an SES light for "catalyst low efficiency."Originally Posted by 99C5R
So you have to turn those off as well.
Thanks for the info though!
2002 Trans Am 6sp, Hurst shifter, short stick,
!skip shift, SLP lid, Holley filter, Dynomax Ultraflow muffler, Jet Hot long tubes and cats, FRA, HP tuners, Hotchkis STB and LCAs. TEA stage 1.5 5.3 heads, Comp 220/224 114 +2, UMI Boxed SFCs
Have the same issue with JetHot. Just delete P0420 & P0430.
Engine Diag->DTCs->
420
430
set to OFF and option 3 (no error reported)
2001 TransAm WS6 Mods? What mods?
I think if you have OBD-II smog nazis though, you want
to not disable the test, but leave it enabled and no
error. Though one day they'll probably catch wise to
that, right now I think they just check that the test is
there.