-
Tuner in Training
FLP Level 4 tranny (NEED HELP, RACING TOMORROW)
I need your help. Since installing the FLP, at wot I can not get the damn thing to shift to 3rd. It just bangs the rev limiter and will not shift. Around town is fine.
Below is my normal, wot speed, and wot rpm:
Normal Table
12 13 14 15 16 18 20 22 24 26 29 32 35 37 39 42 42
23 25 27 29 31 33 34 37 40 43 48 54 61 69 76 78 80
37 39 42 47 54 62 72 84 98 109 118 124 127 127 129 133 139
9 10 11 12 13 15 17 19 21 23 26 29 32 34 36 39 41
20 22 24 26 28 30 31 34 37 40 45 51 58 66 73 74 75
34 36 39 44 51 59 69 81 95 106 115 121 124 124 126 130 136
WOT Speed
42
78
137
39
75
134
WOT RPM
6300
6000
6300
I am going racing tomorrow and need to shift to third.
Thanks, Scott
-
Tuner in Training
Re: FLP Level 4 tranny (NEED HELP, RACING TOMORROW
I think that your commanded shift mph (2-3) is way off. I would try lowering it by a bunch and try it again. Also make sure you copy them into all of the tables (Hot, Performance, Normal). Hope this helps
-
Senior Tuner
Re: FLP Level 4 tranny (NEED HELP, RACING TOMORROW
Those settings look OK (maybe a little low on the 2-3
MPH) for 3.23s and a converter in the 3000-3500 stall
range, but the MPH is marginal for 3.42s and way too
high for anything steeper. What ratio is the rear end in
question; what kind of converter slip?
-
Tuner in Training
Re: FLP Level 4 tranny (NEED HELP, RACING TOMORROW
it was not in the programming but a mechancial error. I will post the final findings later this week!