Results 1 to 7 of 7

Thread: C7 Z06 after diablo intune

  1. #1
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    20

    C7 Z06 after diablo intune

    Hey there - I have a 2016 Z06 A8 and had a diablo intune 2 that I installed their tune and ran it for a while. had looked at its changes via hptune out of curiosity to see the changes. anyhow, been running fine for a few hundred miles. restored the tune using their handheld today as am done poking around and have issue. car starts but jumbles at idle missing etc, throttle doesnt respond etc, reduced power message, cel light, what a mess. obviously the restore tune did not work right.

    I have a full back up of the pre tune calibration on my hptune software - should I just load it and write entire? Want to do it right and get back on the road. thanks for any input

  2. #2
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    20
    unplugged battery for 5 minutes - plugged back and started without issue

    so i spooked the ecu somehow? anyhow - off to test drive... weird

  3. #3
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    20
    for the knowledge base I guess. all good after the drive.

  4. #4
    I'm "diablo" curious also. Mind sharing the file?

  5. #5
    Thanks! Shocked how little they do.

  6. #6
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    20
    diff between 91 and 93 octane was mind blowing for sure....

  7. #7
    Quote Originally Posted by Terry Burger View Post
    Thanks! Shocked how little they do.
    Kinda same here...compared the 93 Firm shift on my L83 truck, pretty simple changes.
    '18 Sierra L5P
    '03 Sierra 4.8/NV 3500: LS6 Cam, HPT Tuned
    '15 Explorer Sport - SCT, AEM (Wife says...it feels faster??)
    '01 Z06