running force motor on MAP

[koolrayz]

Im running a speed density tune and wonder if with the MAF in failure what the force motor has to go off of. I wondered if I could get the force motor to run off of the MAP. I have a big cam so I would need the idle and WOT MAP pressures to know what to make the high and low torque settings for the force motor. Anybody doing this and how would you go about it. Im assuming this requires the pro version which I dont have.
Thanks!

[EC_Tune]

Log your Delivered Torque in the transmission PID section to see where you are on the Shift Pressure tables. The values there will tell you where you are on the Force Motor table.