And I have no problem with that at all. Of course people are going to be concerned about that type of thing. When we started that project, we tried a few different configurations, gathered data, and asked a lot of people what they wanted in a kit. In the end, we ended up with a kit that worked as well as we had hoped, costs less than we expected, and installs much easier than we expected. As far as the fuel puddling concerns, these issues are non-existant. If you tried to run a setup like this at low airflow you might run into that situation. However, it is only used under high airflow and therefore it simply does not happen. Most people don't realize how much airflow a few hundred cfm is. When you are forcing it through a space that is less than 2.5" across, airspeed is extreme. I don't have the exact numbers on me right now, but I remember that we calculated airflows of well over 100mph as it enters the intake manifold. And remember that this is extremely dense, pressurized air. Imagine spraying ethanol into a small airstream that is travelling over 100mph and then try to imagine that fuel just falling down and making a puddle. It simply can not happen.