Morning guys, to swap the MAP sensor on a 02 Corvette LS1, do you have to pull the intake to get to the sensor? I understand it is in the rear. Swapping to a 2BAR setup. Car is not with me or I could look.
THanks in advance!
tt
Morning guys, to swap the MAP sensor on a 02 Corvette LS1, do you have to pull the intake to get to the sensor? I understand it is in the rear. Swapping to a 2BAR setup. Car is not with me or I could look.
THanks in advance!
tt
Last edited by gr8vet; 11-28-2008 at 09:15 AM.
It is easier to pull the intake but it can definitely be done in-car if you don't have giant gorilla hands. A helper with a long flat blade screwdriver is a nice addition as well.
Always Support Our Troops!
Make sure you get the right MAP sensor. I was sold the wrong one (for a 1999 Vette) by Summit.
See attached. The bottom photo is what Summit sold me. There are various threads on this. The 2 BAR that fits the Vette (top photo) comes from a soltice(?) - can't remember.