i have the MVPI Pro interface.
I recently purchased the LC1 and installed it according to the directions. Something is way off because it is showing me AFR arround 20-23. I have looked here, and Innovate's fourms and have found nothing. Here is a list of the diagnositc steps that I have performed.
I logged the LC1 in logworks (works fine there)
I checked voltage (good voltage)
I put it under input one in HPTuners under the LC-1 afr (didn't work)
Changed it to a custom input of (.625 +10) that didn't work
I tried input 2, and used the pre loaded LC1 (didn't work)
I tried input 2 with a custom (Didn't work)
I tried reinstalling HPTuners (incase of a software issue) (didn't work)
I changed the output of the LC1 to 12 per second (didn't work)
Is there something else that I can be missing? Since it worked fine in LogWorks, I must assume the issue lies with the HPTuners. I don't know what the next step would be. If anyone has any ideas please share them with me. Thankyou for any valueable inshight that you can provide.
I will include a copy of a scan so that you can see what it is doing. It seems that the readings are only a bit off, then once the Wideband warms up, the readings go off the chart.
I calibrated the unit according to the LC1 manual, remember, it works in logworks, but not in HP.