LC-1 Install - Confused - Please Help !!

[bigboykilroy]

OK - I finally purchased a LC-1 Wideband.
Im so confused on the wiring of this thing. I have the Pro Ver of the HP Tuners EMI.
I have searched the forum and am more confused with every post i come across.
The LC-1 That I have only has 6 wires all of the posts that i find they have 7wires, mine has no green wire that they talk about. I dont want to hook it up as a narrowband.
Mine has a RED, BLUE, WHITE, BLACK, YELLOW and BROWN.
Please help !!

[bigboykilroy]

Anyone ??

[bigboykilroy]

No One Has A Lc-1 Wideband Hooked Up To A Pro Eio?

[rrmccabe]

I do. Have it connected to HPT Pro and XD-16.

a. Red 12V supply
b. Blue Heater Ground
c. White System Ground
d. Yellow Analog out 1
e. Brown Analog out 2
f. Black Calibration wire

Here is your wiring for the 6 wire.

Rich

[bigboykilroy]

Thanks.

[bigboykilroy]

Just to let everyone know who gets the new ver of the LC-1. It does not have a green wire. The New wiring has 6 wires instead of 7. Per Innovate and HP.

Red - 12+ Switched with inline10amp fuse
Blue - 12- ground, best ground is the - batt terminal.
Brown- Pin 1 of EIO input
Black - Hooked up to the LED and grounded to the car chasse.
Yellow - output to a AFR gauge
White - different ground to the chasse.

This is how i just hooked mine up and it works great.

[Reucroft]

I bought the new version of LC-1 with only 6 wires.

Attached is the wiring diagram I used.

This uses the existing power/ground and stock narrowband connections for the simulation. If you go this route make sure you match up the power/ground from ther stock connector to the Innovate.