Page 445 of 832 FirstFirst ... 345395435441442443444445446447448449455495545 ... LastLast
Threads 8881 to 8900 of 16628

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 247,067
    TheMechanic
    06-06-2023 Go to last post

  1. E38 Remote start

    Started by verlon, 11-01-2015
    • Replies: 0
    • Views: 1,108
    verlon
    11-01-2015 Go to last post

  2. LS2 VE GTS Stock Tune 6L80E

    Started by THE CHAD, 11-01-2015
    • Replies: 0
    • Views: 986
    THE CHAD
    11-01-2015 Go to last post

  3. How to set up 90mmDBW motor, actuating two 4 barrel throttle bodies?

    Started by GrannySShifting, 10-01-2015
    10 Attachment(s)
    • Replies: 19
    • Views: 6,224
    blownbluez06
    10-31-2015 Go to last post

  4. E38 ECM Tach Output interference?

    Started by Stubbs, 10-18-2015
    1 Attachment(s)
    • Replies: 4
    • Views: 2,755
    DSteck
    10-31-2015 Go to last post

  5. Anybody using Narrow Band simulators on a LS3??

    Started by rao, 10-28-2015
    • Replies: 5
    • Views: 2,578
    FunkedOut
    10-30-2015 Go to last post

  6. Help needed! How to setup and log Lambda error for flex fuel

    Started by DRTWRK, 10-23-2015
    3 Attachment(s)
    • Replies: 8
    • Views: 4,279
    DRTWRK
    10-30-2015 Go to last post

  7. L18 TCM Read Protocol Not Detected

    Started by nskaats, 10-30-2015
    1 Attachment(s)
    • Replies: 1
    • Views: 1,311
    nskaats
    10-30-2015 Go to last post

  8. Lightbulb Looking for input/critique of tune - not sure what's awry ... 2012 Corvette w/ Blower

    Started by MM Alexander, 10-27-2015
    3 Attachment(s)
    • Replies: 2
    • Views: 2,117
    schpenxel
    10-29-2015 Go to last post

  9. Do I need to change the tune?

    Started by the gaurd, 10-28-2015
    • Replies: 3
    • Views: 1,521
    schpenxel
    10-29-2015 Go to last post

  10. What are ya doing to the 07 pcm hig/low MAF on boost?

    Started by 02Ls1, 10-27-2015
    1 Attachment(s)
    • Replies: 11
    • Views: 3,912
    schpenxel
    10-29-2015 Go to last post

  11. Need idle help for my first cammed auto

    Started by BigMike42, 10-22-2015
    3 Attachment(s)
    • Replies: 5
    • Views: 2,376
    schpenxel
    10-29-2015 Go to last post

  12. 2014 Camaro SS L99 Boost Timing curiosity

    Started by JST1970, 10-26-2015
    • Replies: 4
    • Views: 2,289
    JST1970
    10-28-2015 Go to last post

  13. Misfire when using low throttle

    Started by reubone, 10-20-2015
    2 Pages •
    1 2
    • Replies: 20
    • Views: 9,197
    reubone
    10-28-2015 Go to last post

  14. CTS-V going into REP under WOT near peak power....HELP!!!

    Started by edmundu, 10-23-2015
    2 Attachment(s)
    • Replies: 4
    • Views: 1,999
    cesar
    10-28-2015 Go to last post

  15. CTS-V Flex Fuel Timing

    Started by doc350, 11-25-2014
    1 Attachment(s)
    • Replies: 13
    • Views: 15,684
    cesar
    10-28-2015 Go to last post

  16. Idle tune issue

    Started by shamanizim, 10-27-2015
    • Replies: 1
    • Views: 1,353
    SultanHassanMasTuning
    10-28-2015 Go to last post

  17. Throttle going to 50% under WOT

    Started by tjwong, 10-27-2015
    • Replies: 0
    • Views: 831
    tjwong
    10-27-2015 Go to last post

  18. 2005 GTO speedo calibration

    Started by tjwong, 10-19-2015
    • Replies: 3
    • Views: 2,093
    dually681
    10-27-2015 Go to last post

  19. Looking for reliable Magnuson TVS2300 kit Injector data Ls2 GTO

    Started by Pabs1, 10-25-2015
    1 Attachment(s)
    • Replies: 6
    • Views: 2,868
    Lakegoat
    10-27-2015 Go to last post

  20. e40 reduced power safe mode problems

    Started by dually681, 10-26-2015
    • Replies: 4
    • Views: 1,846
    Lakegoat
    10-27-2015 Go to last post
Page 445 of 832 FirstFirst ... 345395435441442443444445446447448449455495545 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.