Page 166 of 831 FirstFirst ... 66116156162163164165166167168169170176216266666 ... LastLast
Threads 3301 to 3320 of 16614

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 245,028
    TheMechanic
    06-06-2023 Go to last post

  1. Ls1 to LS3 injector data conversion for L59 injectors

    Started by AJK13, 12-06-2020
    • Replies: 0
    • Views: 1,266
    AJK13
    12-06-2020 Go to last post

  2. Strange idle problem

    Started by Martijn, 12-06-2020
    • Replies: 0
    • Views: 719
    Martijn
    12-06-2020 Go to last post

  3. 2011 Silverado speed limiter trouble

    Started by codyvette, 12-04-2020
    • Replies: 5
    • Views: 1,403
    5FDP
    12-05-2020 Go to last post

  4. LSA Swapped 2012 4.8L Silverado tune/stumbling issues almost gone

    Started by Nachojoey, 12-05-2020
    2 Attachment(s)
    • Replies: 0
    • Views: 815
    Nachojoey
    12-05-2020 Go to last post

  5. Angry rolling idle issue

    Started by andyvillen, 11-23-2020
    10 Attachment(s)
    • Replies: 8
    • Views: 2,397
    andyvillen
    12-05-2020 Go to last post

  6. Right amount of fuel in tank when tuning?

    Started by Varto20, 12-05-2020
    • Replies: 0
    • Views: 952
    Varto20
    12-05-2020 Go to last post

  7. Replaced E40 with new one, ecm can not connect anymore

    Started by Tapi, 12-05-2020
    • Replies: 0
    • Views: 756
    Tapi
    12-05-2020 Go to last post

  8. E40 Fuel Density

    Started by theone61636, 12-02-2020
    • Replies: 10
    • Views: 2,121
    LSxpwrdZ
    12-05-2020 Go to last post

  9. Startup idle surge MAP sensor?

    Started by 5ft24, 11-22-2020
    2 Attachment(s)
    • Replies: 8
    • Views: 2,898
    5ft24
    12-04-2020 Go to last post

  10. Disabling EVAP purge during boost?

    Started by NotSure, 12-04-2020
    • Replies: 4
    • Views: 1,574
    wildfan1976
    12-04-2020 Go to last post

  11. Can a 5.3 LC9 w/ DOD hardware still installed run on modified C6 tune?

    Started by 325_53, 12-03-2020
    • Replies: 3
    • Views: 2,181
    mbray01
    12-04-2020 Go to last post

  12. 2013 boosted Silverado tune irregularities

    Started by andyb756, 12-02-2020
    • Replies: 0
    • Views: 676
    andyb756
    12-02-2020 Go to last post

  13. Gmpp ls3 mil on, no codes

    Started by twinturbo, 12-02-2020
    • Replies: 1
    • Views: 724
    twinturbo
    12-02-2020 Go to last post

  14. Can someone hep me identify what is causing his fueling swings with fuel trims?

    Started by joegibbstruck, 12-02-2020
    6 Attachment(s)
    • Replies: 2
    • Views: 963
    Jeff7577
    12-02-2020 Go to last post

  15. E38 Randomly +20% Rich

    Started by TAPyvehc93, 11-25-2020
    5 Attachment(s)
    • Replies: 17
    • Views: 4,470
    Jeff7577
    11-30-2020 Go to last post

  16. Permanent code clearing strategy

    Started by avmaviator, 10-01-2020
    • Replies: 3
    • Views: 2,923
    Jeff7577
    11-30-2020 Go to last post

  17. Thumbs down twin turbo 5.3 dbw termX tandum with stock pcm going wot i get limp mode

    Started by TTahoe, 11-04-2020
    • Replies: 9
    • Views: 3,040
    TTahoe
    11-30-2020 Go to last post

  18. Cool Launch controle mustang 2014 3.7 V6 307HP

    Started by performance33, 11-28-2020
    • Replies: 1
    • Views: 1,007
    f.creek-ranch
    11-30-2020 Go to last post

  19. Question Looking for advise please.

    Started by CHEVYGUY5777, 11-29-2020
    4 Attachment(s)
    • Replies: 3
    • Views: 1,279
    CHEVYGUY5777
    11-29-2020 Go to last post

  20. New to tuning

    Started by JamesSmeby, 11-29-2020
    2 Attachment(s)
    • Replies: 1
    • Views: 1,480
    Lakegoat
    11-29-2020 Go to last post
Page 166 of 831 FirstFirst ... 66116156162163164165166167168169170176216266666 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.