any one have a file with this setup properly and working correctly as it is slightly different then the older coyote stuff. or a write up on how to achieve this..
any one have a file with this setup properly and working correctly as it is slightly different then the older coyote stuff. or a write up on how to achieve this..
EVC mapped point 1=40
Evc mapped point 2=40
IVO mapped point 1=-60
IVO mapped point 2=-60
Idle speed(s) 825
RPM error from desired to begin idle control (not sure of ID in HPT)= 300
Min mph for idle= 0 (Not sure of ID in hpt)
You can play with VCT delay also if you want it to come in faster/later from startup.
These are just numbers to get you started, but its a good start. I use different software so my setup is different. Like I said this should get you started. you can play with the IVO/EVC/idle speed to get the sound you want.
Youll also have to dial in your fuel trims (I'm sure you know this also)
Last edited by Dolsvt00; 02-18-2016 at 11:59 AM.
Dolsvt00,
are these the complete steps to setup ghost cams on 2015+ GT/SHELBY GT350? Any updates would be awesome...
thanks..
Did you have an issue with the mapped points jumping all over? Made some change and it would stay is 1-2 but then jump all over and get a little rough.
Bump for the 15+ gt350
Other than needing to work on the fuel trims a little more here is my tune file for 2015 gt.
seans-GhostCam2.hpt
How does it run Sean ? You told me it worked out but curious to how you liked it .