6.2 Manual Swap no VSS

[Neil_Foster]

Ive got a 1967 M100 that I have swapped a ford 6.2L V8, ZF6 manual and the 2011 f250 chassis into. Right now the truck has no source for a VSS. I believe in 2011 the F250 used the ABS system to calculate speed. I have completely eliminated the ABS system and have no location to get a VSS signal. There is no output from the transmission, and my rear end also does not have an output. I can not find a pin in the pcm that would even accept a VSS. I am wondering if I set Use Tire Circ to Calibration, and Use Final Ratio to Calibration, if the speed can be calculated? I just want the PCM to know when the truck is in motion. If it can not be calculated. Does anyone know how to get a VSS to the PCM and set HP tuners to use than rather than the ABS speed?

[B E N]

VSS came from the trans, look in that harness for the pin.