Maybe these are things that can be updated or there is some setting that I can't figure out.
Can't slide graph to right to check MAF trims (or any graph that extends beyond the edge of the screen)while scanner is running. Keeps snapping back to the left.
If I want to look at what my trims are doing at 6500 Hz, I can't do it without stopping the scanner.
The scanner won't update IM monitors automatically. Must keep clicking "Read DTCs" button. That's pretty hard to do while driving. 2.24 auto updated every few minutes. I spend a LOT of time trying to get Monitors to run in order to get cars to pass the California SMOG test.
When trying to highlight and copy a section of the MAF vs LTFT graph, or any MAF based graph that extends beyond the border of the screen it goes extremely slow. Not smooth like in 2.24
It took 25 seconds to highlight from 2100 Hz to 10050 Hz on an 08 Corvette. Once it gets to the edge of the screen it takes forever for the graph to move left. The editor does not do this. It's almost instant.
Yes, I can highlight a particular box then hit shift and highlight another box to copy what's in between but I don't want to do that. I want to be able to slide left and right at will like before.
What happened to the "load all data" and "clear all data" buttons? Can't clear a graph without stopping the scanner. If I'm scanning and reset the fuel trims, I can't get rid of the old data without stopping and restarting the scanner.
Thanks