Any one know the output voltage vs frequency for a GM delphi MAF sensor?
Any one know the output voltage vs frequency for a GM delphi MAF sensor?
Last edited by Zero4488; 02-15-2014 at 10:45 PM.
I'm not sure what you're asking. The MAF outputs a logic level frequency based on airflow.
DSX Tuning - Authorized HP Tuners Dealer
http://www.dsxtuning.com
http://www.facebook.com/dsx.tuning
Just say no to bull s***.
IF YOU WANT HELP, POST A FILE!
It's always on a 5v level. If you want to convert it to a voltage, you either need to program a microchip to do it for you, or make a digital to analog converter with a LM2917.
DSX Tuning - Authorized HP Tuners Dealer
http://www.dsxtuning.com
http://www.facebook.com/dsx.tuning
Just say no to bull s***.
IF YOU WANT HELP, POST A FILE!
Could measure the rms value...treat it like AC.
Ed M
2004 Vette Coupe, LS2, MN6, Vararam, ARH/CATs, Ti's, 4:10, Trickflow 215, 30# SVO, Vette Doctors Cam, Fast 90/90, DD McLeod, DTE Brace, Hurst shifter, Bilsteins etc. 480/430
ERM Performance Tuning -- Interactive Learning ..from tuning software training to custom tunes
HP Tuners Dealer- VCM Suite (free 2hr training session with purchase), credits and new Version 2.0 turtorial available
http://www.ermperformancetuning.com
http://www.facebook.com/ERMPerformanceTuning
[email protected]
The MAF outputs a voltage waveform that swings between 0 and 5V and whose frequency is proportional to the airflow. You can measure the average or the RMS value of the voltage with the appropriate voltmeter, or you can look at the frequency with a scope. Unfortunately with an approximately square wave of 50/50 duty cycle the average and the RMS value will not change with frequency. If the waveform is PWM (pulse width modulated) then you will see different voltages. I believe the MAFs on LS engines are of the former type.
It's frequency modulation.
DSX Tuning - Authorized HP Tuners Dealer
http://www.dsxtuning.com
http://www.facebook.com/dsx.tuning
Just say no to bull s***.
IF YOU WANT HELP, POST A FILE!