Hello,
Does anyone know how to setup the 3 bar SD OS with regards to the MAF fields?
I don't have a MAF sensor physically installed and I don't know if you are to still set the MAF to fail like you would for VE tuning calibration?
Without a sensor present would the PCM observe a signal > 0 htz to cause it to fail or would it just stay at the lowest value in the MAF Hz table?
Also, the SD OS states that it maintains the function of the high and low octane tables. If I set the MAF to fail would this still divert to the low octane table? How would I control what spark table the PCM is using during tuning?
Lastly what would the effect be on this OS be if steady state was prevented by changing the Steady State parameters under Airflow -> Dyanamic ?