From what I can find, these injectors flow 42lb on a 58psi rail, rated at 43.5 psi. Using "The tuning school" way of imputing the injector flow rate into the table, and dropping pulse width down to the .950 range I can't get this car to smooth out on the VE. No matter what I adjust with the injector flow rate, I get constant rich/lean conditions in the VE with huge spikes. It will not smooth out, and the car runs like crap in both VE and MAF mode while trying to tune.
FYI, the "tuning school" way of doing it in their book is to look at the stock injector table. Subtract the figure @ Zero KPA from the figured @ 80kpa. Which was 2.6. Then calculate flow date of new injectors which according to the HPtuners calculator was 48.5. Put 48.5 in the zero KPA cell, add 2.6, which was 51.1 and add it to the 80kpa cell. Then "interpolate section" to fill the rest of the data.
Where can I get the correct data to get these injectors input correctly? Also, what other tables besides pulse width should be modified?
Thanks