I'm having ETC issues that I can't seem to sort out. I didn't have this issue when it was naturally aspirated. Now the ecu(p59) wants to close my throttle body when I stab the throttle, either from a stop or a 2nd gear roll. I've swapped to a Nick Williams TB from a factory LS2 and it still does it. Most of my torque management is removed, other than 2% of timing I remove at shifts. So idk why the tps closes the throttle when the pedal is at 100%. So, would seeing more than the 640 value limits cause the ETC to kick in/out under load? BTW, it does fine on the dyno, but exhibits this problem under real world load.
Can I override those 640 limits or will it actually "put your module in an unrecoverable state" as the pop up warning says?