so i've got a 2010 zr1 with a stock long block and id1300 injectors... 2.35 pully with a lpe snout....
i've been tuning the vve table as best i know how, and just started running in to this lugging / jerking at low rpms.... 1200rpm and lower...
no issues with wot that ive found, stays around .78-.82 lambda...
not sure what the hell i've done to get these insane vve table spikes, but i'm finally asking for a hand here...
i've got an aem 30-334 wideband reading via obd into mvpi2 and have been following what the scanner has said to adjust...
maybe i need to reflash with a stock tune and then add in all my changes?
maybe i'm trying to do the vve tuning wrong? i disabled the fuel trims / maf because thats what i've been reading...
i appreciate the assistance in advance!
if i need to add some channels or get more log i can do that....
also would be open to a remote session, i have laptop with hotspot....
FUCK.hptfuck.hpl