E40 PCM with 2 bar OS. Trying to lock in speed density. MAF sensor is completely removed from vehicle. At 4100rpm the air calc mode goes from low speed to high speed and from what I understand that means its in maf mode. I've reduced VE tables in half and it doesn't respond to changes over 130kPa when switching to "high speed". Tried several changes and nothing seems to work. This happens each and every time the vehicle sees high load/rpm.
I've made all cal changes from the guides on locking VE: zero'd maf fail, set P0101/2/3 to mil on first error. I've read some people have issues when scanner is logging maf channels so I removed those and it still isn't helping.
What am I doing wrong here? cal and log attached
Justin 5.3 Swap 2 bar 10.hptcal 10 2nd gear pull log.hpl