I see in the VCM Scanner that parameters are available in the Focus RS RDU....
Capture.PNG
Are there any plans to add tuning support to the RDU??
I see in the VCM Scanner that parameters are available in the Focus RS RDU....
Capture.PNG
Are there any plans to add tuning support to the RDU??
I was out doing some data logging on one last night.
Awesome new support PID?s. Very pleased.
If you're using the latest Beta, you can re-read from your vehicle and the RDU will be part of the process. There are a few parameters available for the RDU, I'm working on adding more, but its a slow process of reverse engineering them directly and testing them.
Currently I have the thermal limitations and that's about it.
Loving your work Steven. Loving it. Thank you.
Thanks Steven!
I was able to read the RDU but only if didn't read the ECU also.
When I tried a full read of both controllers, the software presented Invalid Checksum error and File Failed to Load. It saved the file, but when trying to open the file I get the same Invalid Checksum error.
I'm currently using v.3.7.625.
This one is odd, can you send the file you read that way to [email protected]?
When I test with my bench ECU setup, its a read of both at the same time.
I'd probably want some control over how much torque goes into the rear (lockup the RDU clutch sooner or more aggressively).