TM issue on e38
Can anyone explain what causes these TM pid's to enable? Is it the TCS or something else? I have all TM disabled but for some reason I keep getting these 2 pid's turning on and pulling timing. Been fighting this for months now and no one can seem to figure out whats causing it.
1970 Monte Carlo L96/4l80 swap
2008 Pontiac Torrent GXP 3.6vvt/6l70
most likely traction control or rpm limiter, i use ETC and fuel cut for my limiters and traction and they do show up in that, fuel cut or ETC torque will say "RPM lim" when your on limiter or TC when its active
Hey bud I saw your other thread as well. Wanting to help you out as I have worked through some issues on my 3.6L Malibu, but I can't seem to see any attachments. I don't really like this new forum. E-mail me or pm if you can username at gmail and I will help you as much as I can! Send over your tune and log if you could.
you didnt by chance zero out the abuse mode>torque reduction and reduction duration stuff on the trans tq mgmt side? if so that could be it.
08 GMC rcsb 2wd. 4.8/4L80e with a dollar store turbo.
best so far of 7.25 @ 97.4 1/8 mile
Reply With Quote