As I cannot use the AEM via OBD since I have an 06 I moved the pins to the output of the gauge , but cannot seem to get it to come up In the scanner. Does anyone have any tips to get the gauge to show up in HPT (3.6).?
As I cannot use the AEM via OBD since I have an 06 I moved the pins to the output of the gauge , but cannot seem to get it to come up In the scanner. Does anyone have any tips to get the gauge to show up in HPT (3.6).?
Which output? Serial or analog? Not sure I understand what you are trying to do but you can't just take the gauge analog out (Pins 9/10 connector A) or Serial (Pin 5) to the OBDII connector. You need to add separate wires with the analog out going to pins 1 an5 respectively of the MPVI green connector and if looking for serial, need to tie pin 5 to a DB9 connector pin 2 and aground to pin 5 and then connect that to a serial to USB converter cable. Run your transform in accordance with you selection of analog or serial.
Ed M
2004 Vette Coupe, LS2, MN6, Vararam, ARH/CATs, Ti's, 4:10, Trickflow 215, 30# SVO, Vette Doctors Cam, Fast 90/90, DD McLeod, DTE Brace, Hurst shifter, Bilsteins etc. 480/430
ERM Performance Tuning -- Interactive Learning ..from tuning software training to custom tunes
HP Tuners Dealer- VCM Suite (free 2hr training session with purchase), credits and new Version 2.0 turtorial available
http://www.ermperformancetuning.com
http://www.facebook.com/ERMPerformanceTuning
[email protected]
I'm sorry I wasn't very specific when I wrote that. I have my WB connected and reading in the channels section of the scanner but I cannot get it to display in the graph section. THATS what I'm trying to figure out.
https://www.youtube.com/watch?v=3TQdrTMnljI
https://www.hptuners.com/forum/showt...-PRO-Interface)
Have a look at those two links, hopefully they can help you.
Post log and current layout.
Post a log and tune if you want help
VCM Suite V3+ GETTING STARTED THREADS / HOW TO's
Tuner by night
CPX Tuning
2005 Corvette, M6
ECS 1500 Supercharger
AlkyControl Meth, Monster LT1-S Twin, NT05R's
ID1000's, 220/240, .598/.598, 118 from Cam Motion
2007 Escalade, A6
Stock
thanks to your prior write up I got it figured out. I am having a MAP sensor issue wont show any reading past 105kpa and i know im over 200kpa THANKS AGAIN!!!!Originally Posted by schpenxel
6-26 cruise home.hpl
her Is attached log see any issue????
What ECM do those run? And what MAP sensor are you using?
Reply With Quote