manual to auto swap

[izazzel]

i am doing a 411 ecm swap on 97 camero istarted with a 2002 firebird file with t56 the car is a 4l60e. i segment swapped in the 4l60 info but it doesnt seem to see p/n. the idle speed will not change in p/n if ya put it in gear it goes to the idle table setting and doesnt change until keyed off. i hooked up the snap on and desired idle in p/n shows 0 any ideas on how to fix this or do i have to start with an auto file to get desired idle in p/n

[izazzel]

here is the file joe 383 tune2.hpt

[CodeRed26]

idle is set to 1200 on all three settings in Engine> idle>target idle rpm maybe try changing the in gear targets to what you want it to idle at in gear and in P/N?

[izazzel]

doesnt change start up idle is only running off of base airflow and scanner shows 0 desired idle

[CodeRed26]

im sure someone more competent will chime in but maybe something went wrong with the segment swap.