Originally Posted by
Mark@TuckerPerformance
There is no actual sensitivity table for the LFX. Knock Sensor Lever Multipliers tables multiply the knock when not in transient mode only (which is pretty much never if the Transient Mode tables are left stock). The Transient Multiplier table is the multiplier when in transient mode (which is pretty much always if the Transient mode tables are left stock), which is factory set to 1.0 across the board already.
But something you can look into also that might help you get this knock issue solved, if you haven't already. Is to raise the Knock Retard Decay Rate table. This table is how fast knock retard is removed once knock is no longer being detected. Factory table is very low, so knock takes forever to go away. So I typically set to 1.0 across the board, but I have seen others go even higher (being removing knock faster).
So to clear this up, don't even mess with the Knock Sensor Level Multiplier. You won't get any results from messing with them.