Looking for some help setting up ghost cams on my shelby i have these steps is there anything else i am missing
EVC mapped point 1=40
Evc mapped point 2=40
IVO mapped point 1=-60
IVO mapped point 2=-60

Idle speed(s) 750 +
RPM error from desired to begin idle control (not sure of ID in HPT)= 300

Min mph for idle= 0 (Not sure of ID in hpt)

You can play with VCT delay also if you want it to come in faster/later from startup.

These are just numbers to get you started, but its a good start. I use different software so my setup is different. Like I said this should get you started. you can play with the IVO/EVC/idle speed to get the sound you want.

dial in your fuel trims

any assistance would be great. thanks all