Hi
I've a question about the PCM (or configuration) of a 99 Corvette C5.
I've done a A4 to MN6 conversion at my car.
Everything is fine and I change the parameters in the original A4 OS to the settings of the MN6 (99er C5).
Car is running fine.
Now one thing is strange: As it was with the A4, the DIC can show me the Transmission Temperature and I want to use this function again with the MN6.
I hooked up a new temperature sensor and connected it to the same wires as for the A4 (going to Pin 51 of the PCM and Ground)
But the DIC just shows 0?C or 32F.
If I change the PCM back to A4 (only switched from Manual to 4L60e in the Transmission section) it shows the correct temperature again.
If I reprogram it back to Manual it changed again to 0 (32F)
Is there a way to get both things work together, setting to manual and that the PCM reads the information from the sensor and shows it at the DIC?
I also checked the information in the Scanner tool, and it has the same behavior.
Andy Ideas?
Thank you
Kind regars
Birger