Originally Posted by
The Shop Inc
I have an LM2. output #1 going to my Dyno. Output #2 to the HP pins 1&5. I have also tried switching these two outputs. They are both putting out the same voltage.
The display on the scanner will read wrong most of the time but then sometimes toggles to the correct reading. I was measuring voltage drop, etc. I noticed there is a .350v on #1(#2 as well) of hptuners.
I configured my own pid for Wb as well as tried the lc1 pid. My configure with car idling will be at 1.45 lambda and go to 1.0 sometimes and with lc1 pid will be 19:1 and trigger to 14.7 sometimes.
What am I missing??
Thanks!