no skipped mph's in chart display scans

[murphinator]

is there anyway to increase the resolution so that when you drag between 2 mph points in the chart display that every mph in between is included in the scan ?

this would be very useful when doing 0-60 ,0-100 , 60-100 etc... using the elapsed scan time at the bottom of the chart screen to verify/quantify improvements in performance

some scans wont register above 0mph until moving 2mph skipping 1mph alltogether or will show 59 & 61 mph - but you cant get it to show 60 mph when you know it had to be doing 60 at some point in time between 59-61

I know I am not the only guy on here using this elapsed time feature as a timer - the cobalt guys post about 60-100 results frequently

[Chris@HPTuners]

the scanner displays every frame of data received from the PCM. If the vehicle speed changed by 2 mph in the time of one frame there's nothing we can do about that.

[murphinator]

the scanner displays every frame of data received from the PCM. If the vehicle speed changed by 2 mph in the time of one frame there's nothing we can do about that.

gotcha , had to ask

[8850]

Use a taller gear. I have an 08 A6 Corvette. I can put it in 3rd paddle with the converter locked at 25 mph. I get almost every mph read. In second gear lit will skip 4+ mph in multiple some frames.

Comparing exact frames I can get a pretty good idea of improved performance with changes going from about 25 mph to about 120 mph all in 3rd gear.

[Bill@HPTuners]

8850 you need to keep in mind you are using a pcm that can get 40fps, he's using one that gets between 5 & 20 max fps.