I have changed the sensor on my ECT and the old sensor is the only one that works. When i install a new one, the temp guage stops working unless i clear the codes. Then it works for maybe five mins and i have to do it again. The old sensor works, but the plastic connector on the end of it is broken off, so sometimes the plug comes out of the sensor. Ive also been throwing these other codes. The MAF is brand new, too... so i dont know what thats about. Plus the clutch switch was just replaced to try to get rid of this code. It didnt work. The only thing that i can see being right is the EGR code. That is normal, since i deleted my EGR. What gives?
PCM - p0103 - Mass Air Flow (MAF) Sensor Circuit High Frequency (History) (Immature)
PCM - p0118 - Engine Coolant Temperature (ECT) Sensor Circuit High Voltage (SES) (Pending) (Old) (History) (Current)
PCM - p0405 - Exhaust Gas Recirculation (EGR) Position Sensor Circuit Low Voltage (Pending) (Old) (History) (Current)
PCM - p0704 - Clutch Switch Input Circuit Malfunction (Old) (History) (Current) (Immature)
Restraints - u1000 - Class 2 Communication Malfunction (History) (Immature)
Restraints - b1001 - Option Configuration Error (History) (Immature)
Restraints - u1016 - Loss of Class 2 Communications with VCM (History) (Immature)
Restraints - u1040 - Loss of Class 2 Communications with ABS (History) (Immature)