After tuning with WB, then ?????

[gr8vet]

Tuning with WB.

cpig's guide states to setup open loop speed density.

Set DFCO to 284
Set Open Loop EQ ratio to 1.00
Disable LTFT
Set Closed Loop enable temps to 284
etc., etc.

OK, the dummy I am, after you log data and complete tuning process. Which of the above are changed back to original state? Some are obvious, some I am not sure if you leave alone of change?

thanks in advance.

tt

[gr8vet]

Is there anyone out there?

tt

[5_Liter_Eater]

If you understand what each setting is you can choose for yourself. Personally I would revert everything back except for LTFTs and OLEQ. I like to keep LTFTs disabled and run on STFTs. There is no reason to have an OLEQ different than 1 (14.7) except for cold start up ECTs.

[gr8vet]

Thanks for the reply Bill, I appreciate your response.