Ok, again, thanks everyone for the help! I've learned a lot over the past month working on this tuning and I finally have things running pretty smooth. The truck is really starting to run good and feel smooth.
I had the opportunity to make some full throttle runs from 55-90 while passing. I've not pushed the tune that hard up to this point as I wanted to make sure it was safe. I had a few weird discoveries in the higher rpm's, and i'm hoping you guys can help shed some light on things:
1) My VCT is going to a "disabled" state, i can't understand what would drive that, but it happened on both pulls (4:47:03 and 4:49:34)
2) Additionally, I have OP turned on in the MP Configuration, but it doesn't appear spark is entering the OP table. And, it comes out of MP0 during the run and floats around (MP0 had been my full load table before OP was turned on). This drift appears to correlate with the knock event.
Let me know if anyone sees what may be causing my issues.
Thanks!
Attachment 145770
Attachment 145771
*Note: this was posted under an older thread I had created, but with no response I thought I should make it a new thread since it is a significantly different topic. I am deleting my other thread so its not in here twice. Thanks for understanding :-D