Search:

Type: Posts; User: Hurricaneoffroad

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,692

    Wow Ive been leaving so much on the table. Thank...

    Wow Ive been leaving so much on the table. Thank you
  2. Replies
    2
    Views
    1,692

    Am I missing something?

    Thus is all I sse. Is this correct? I cant see rail pressure or pulse widths
    65880
  3. Have you adjusted your clutch fill rate?

    Have you adjusted your clutch fill rate?
  4. Ok I figured out my problem. The shift points...

    Ok I figured out my problem. The shift points were all running together. Thanks for help and your right it feel like new truck when locking out. The factory 6.0 converter is actually a little too...
  5. I'm think my problem is in my tip-in for TCC...

    I'm think my problem is in my tip-in for TCC release. Are you familiar with those 5 different tables under TCC release? I tried your trans setup on my truck and it worked great except for not locking...
  6. Well mine is kind of tricky. I have a common rail...

    Well mine is kind of tricky. I have a common rail cummins in my 05 F250 in place of my 6.0 and I'm using my factory TCM to control trans. Its working excellent but I cant get it to lock out early in...
  7. 5r110w behind common rail cummins conversion

    Need help getting trans to lock up in 3rd and shift out while locked out. Any help would be greatly appreciated. This is my setup as of now 63503
  8. If you don't mind me asking how are you getting...

    If you don't mind me asking how are you getting trans to lock out in 3rd?
  9. Replies
    2
    Views
    2,030

    Invalid checksum on 05 Excursion

    Invalid checksum on 05 Excursion 6.0 auto. Not sure what this means. Tried reading a few times. Need help please
  10. Replies
    9
    Views
    5,620

    I went back and checked the stock file on the...

    I went back and checked the stock file on the truck I got tune from which is an 06 model. Its stock setting is at 20kpa for VGT overboost min. So it has to with strategy I'm assuming
  11. Replies
    9
    Views
    5,620

    Ok it was the "VGT overboost min" set too high....

    Ok it was the "VGT overboost min" set too high. It was on 20kpa and I set it at 0 like stock and VGT now works as its suppose to. Has full power. I'm thinking it was set higher bc that tune was setup...
  12. Replies
    9
    Views
    5,620

    59698

    59698
  13. Replies
    9
    Views
    5,620

    Yes worked great with stock tuning. . Even...

    Yes worked great with stock tuning. . Even crusing down the road its reading 0-2 psi when it should be closer to 8-10.It has no bottom end. If you hold it out it starts pulling hard on big end
  14. Replies
    9
    Views
    5,620

    59581 EBP at 350kpa when idling and vgt stays at...

    59581
    EBP at 350kpa when idling and vgt stays at .44 and drop with rpm. Changed ebp sensor and checked harness resulting in no change
  15. Replies
    9
    Views
    5,620

    6.0 Tuning VGT issue

    Hey guys new to tuning with HPT. Loaded a custom tune and now vgt starts at .44 and goes up. So truck has no bottom end. Its a 2005 F250 6.0 auto. Everything worked great with stock tuning. Compared...
Results 1 to 15 of 15