Search:

Tried re polling the parameters. That means deleting the vehicle file and having the scanner go through the compatible pids right? Cause I did that and no change :/. Oh and of course the one in the...

Ok so I set the p0101 and p0102 to mil on first error in the DTC section. I'll go out and restart on the VE thanks

Hmm ok. I thought I had it set to fail on the first time. Was just following the directions in the user submitted help section. Good to know about not logging the MAF. The code should be present but...

I will post up a better scan tomorrow thanks. Heres the tune.60907

Hello been trying to get my engine tuned for the track this friday and running into some issues. First I just updated hptuners and now the narrowband o2s, TPS, and the MAF sensor aren't being read....

I didn't go into PE because my tps setting on it is 90% so no issue there. Still confused on why the wideband isn't reading correctly :/ but ah well I shall try doing another free air calibration

I meant EIO if that matters. I believe I have the newest version as I bought it this august? And hmm very true thanks I'll look into that

I just installed an LC1 with hptuners did the whole add EOIO and make sure LC1 is selected. Did the free air calibration and such installed the sensor(Which is used). Now I'm reading 7.36 as my A/F...

Just as an update to this as I just realized I didn't say what happened. I'm running SD and took the homemade inlet off and the issues seemed to stop. I also believe it may be because I had a little...

So i'm at 96kPA with key on engine off and 48kPA with engine off. I don't think its a restrictive inlet. It might be collapsing during a first gear pull then. I'll pull it off and check in a bit. ...

Yeah I knew about the injector but its not hitting its max cycle yet? Figured I'd hit that first then worry about it lol. Brand new MAF sensor too :/. The IAT is in the same unit as the MAF. Not sure...

Ok so went out and tested it. Same thing with less harsh results. Engine didn't lose power but didn't gain any either. More like a stumbling action then falling on face. i'm guessing the VE table...

Well definitely not fuel pressure held steady at 59 psi all the way through to 6k where I stopped. Means the tunes off at somepoint.

Hmm yeah my fuel pump has just started to make a high pitched noise so I'll get a fuel pressure tester and take a look. Here is the tune if that helps. If it isn't the fuel pressure what would be the...

I have a 2006 5.3l swap into a 87 camaro. Has a 218/218 .578 cam and home ported heads. Been running on a lightly modified stock tune for a bit now as I haven't had a chance to buy a wideband....