AIR pump?
Type: Posts; User: Alain2
AIR pump?
42lbs stocker injectors???? Stock from what, a new Corvette ZR1?
Anyway...
Your Injector flow rate is all wrong. Your injectors are probably rated 42lbs at 39 or 43.5 psi, If you run 4 bar...
Your stock maf is probably maxed out so you will have to cheat the PE in the high rpm. For exemple with my maxed out MAF at 6400 rpm my EQ ratio commanded is 1.55 to get 11.5 AFR.
Your injectors...
I have an Innovate WB and it works pretty good for me, I don't think the WB is the problem here.
I would try this: increase all the VE in low MAP (15,20 and 25kpa) and also increase the the airflow in the low HZ (3500hz and lower) of the MAF table. It would not hurt anything to try and see what...
Before you start doing WOT and or PE mode passes you should have your VE and MAF tables tuned. You log shows your car is not ''smoothly'' running at stoich. Fix that first.
In stock settings, your...
I don't see WOT pulls either. Was your AFR also all over the place with the stock tune and stock air filter? That would explain a problem with your AFR sensor.
I decided to lower the PE Enable TPS to 55% from 2400 to 3600 rpm. I don't want to go full SD for now, maybe during winter.
You have to add it to the chart settings and histogram settings configuration.
At 100-105 the NA engine is WOT and enters PE mode for best torque. Or does it to be safe?
Do you have a cold start log?
I have a LS6 supercharged T trim Vortech 9 psi on stock motor. The PE Enable TPS is at 64% until 3600rpm then it goes down to 36% at 4400rpm.
When I accelerate in town, between 2400 and 3000 rpm,...
So HP Tuners Pro is a product that doesn't work as advertised.
I bought the Pro to datalog specific outputs but it doesn't datalog user configured outputs???? :mad:
Ok I added the boost gauge while connected to the car, it worked and I could read the gauge on the computer. But I still have the same ''unsupported parameter'' when I close and reopen the software,...
I have not tried yet, I was busy installing a supercharger kit. I will keep you updated soon.
ok I will try that.
I configured (user defined) a boost gauge 15 psi on the EIO Input 1. (volt/0,266)-1,88. It works and datalogs fine, but when I turn and reopen the software it says <unsupported paramter> where the...