Effective area and the predicted tables. Anyone have these from KB? I know they never gave this data out but has that changed? I have tried a half dozen from different sources and so far, no bueno...
Type: Posts; User: Willie
Effective area and the predicted tables. Anyone have these from KB? I know they never gave this data out but has that changed? I have tried a half dozen from different sources and so far, no bueno...
....which is exactly what happened. So the ECM (12624402) was replaced with a 12633016 and tuned with a GXP VIN. Then the tuner changed the appropriate engine values and she runs as she did before,...
.... either a file for a 2009 Pontiac G8 GT with a 6.0L (with DOD) and a manual transmission. This combo does not exist in the states, only Australia, where it would be very common.
I recently...
Do you have a set fee or is your fee time based? And do you charge additional for any products / credits you need to create a tune file?
I cannot seem to figure out why this 168 behaves like it does. I have the commanded idle at 800. When I start the engine (does not matter cold or hot) the idle stabilizes within a minute or so,...
14.08 is the blend we have exclusively here. No such thing as 100% gasoline, so I use 14.08. My numbers are for example's sake only. And Ford uses 14.64 in my tune as stoich, if you want to be...
I've searched everywhere and really cannot find an answer to my specific question, so here goes.
Let's use a 70/30 mix, gas to methanol. Using gas stoich of 14.08, methanol stoich of 6.45. Would...
Stock GT500 TB Data...
I have not seen this discussed at all and it is a thought I had when I replaced a 2.3L blower with a 4.2L. Should the manifold volume be increased?
Does IPC Failure Mode (100) mean anything? This occurs when I lift the throttle...
So I have a slight issue with this TB. When I rev the motor higher than ~3400 rpms and lift, failsafe occurs. It's only when I lift. It can be a loaded or free rev, it doesn't matter. So I called...
I read to disable these codes somewhere but with no explanation. For those in the know, can you explain what these are and why they should be disabled?
Does the fuel pump voltage table need to be changed when changing to higher volume fuel pumps? I have absolutely no experience in this area. Thanks all..
Here is my experience. I installed the 66 years ago. No other changes. Ran fine. I replaced it a couple of years ago with a 72. Again, no other changes needed.
On a second 2008 GT500, I bought...
Yes, it would be nice to see if changing these tables actually makes a difference. Thank you!
Anyone have the TB effective area table for L&M TB's, specifically the dual 66mm and dual 72mm? I have a 72mm on my 2008 GT500 but use the 65mm CJ table because I cannot find ANY info on L&M's....
...