Thanks a lot
Type: Posts; User: hakeem
Thanks a lot
Hi Guys,
I have this car I am working on. it has P3401 active codes. I checked Diagnostic as per Alldata and everything tested fine. wires are ok. I swaped Solenoids and same thing. Only thing I...
Thanks Was easy to do. Just another question please, how did u know I need to do this?
Thanks guys. I will try it again tonight and see what happens.
What is this? any idea how it should be done?
I was trying to tune MAF and during the scan my car started to backfire when slightly increasing throttle. I noticed that I have (1/2 of the last quarter of fuel) and its Factory Five 33 hotrod car....
I am using FRPP part kit however with the NA engine 2014.
Its working for me. I can send the layout for you if you like. however, I am a beginner so please check everything!
are u choosing the...
Thanks. much appreciated. :)
My bad!
One question here please, what unit shoud i use for the pressure ratio?
I have set the EQ error to read from Daytona sensor and commanded.
Thanks
Here it is. I tried to do the graph but its not reading
here it is..
Also, in VCM scanner, I couldnt find o2 sensors for the jeep. I think I should use an external wide band.
Thanks
Hi Guys,
As the topic state, anyone has a channel config for this car that dont mind to share?
Thanks
Hakeem
Hi Guys,
Anyone used this for 2009 jeep srt8?
Couldnt find the MAP label in the tune. the tune has VE for bank 1 and 2, the axis looks like its some kind of factor and RPM?? any suggestions? ...
Thanks for the info.
Do u always turn off o2 sensor when turning off DTC 420/430?
Coz I only turned the DTC 420/430 off didnt do the ETC thing. and it gave all these codes after a while.
Thank you for your prompt response. if you please dont mind also answering these questions;
1) Whats ETC?
2) Is there something I can tune that will lets say increase the threshold or...
Hi Guys,
I am still a beginner so please mind my silly questions. My friend has 2009 Jeep srt8 and he bought high flow catalytic and now giving the above mentioned codes. I do have few questions...
Hi,
Sorry to bring this up again but I do have some questions please;
I have Daytona vi widebad sensors. and under EQ ratio in the transform section there is a daytona sensor wego. Is this...
ok. I really dont know if i get it or I am just confused! let me try to explain what I understood from this. sorry I know its too much but please bear with me.
So,
1) lets say I am using VCM...
Thanks!
let me just check if I got this correctly;
1) So, here in Qatar. I have been told that the Stoich AFR is 14.2. So, I can change 14.08 to 14.2?
2) Also, I have Daytona vi wide band kit....
Hi All,
Sorry if this is a dump question. I am still new to this and a little confused.
Now in the VCM Scanner Channel I can only add EQ commanded. there is no AFR Commanded Channel. I have...
Hi Guys,
I just received my HPTuners and did some work on my car. It`s my first time doing this so I thought I would seek comments and help. All what I did below, was from thetuning school book...