Is there any future plans for tuning these models using HP Tuners ?
Type: Posts; User: tahoels1
Is there any future plans for tuning these models using HP Tuners ?
last night i tried lowering the boost setting and it didnt shift so i started increasing the ongoing pressure and lowering the shift point to where it started shifting fine so i raised the boost to...
I will try it and will give you updates on it
i have a turbo truck 2014 model that now im facing a problem with the trans tune before when the truck was making 650whp it was shifting fine and on point but the problem occurs after we raised the...
I found the issue the car was valve floating baaad i changed valve spring and the car is mint :)
Crank sensor has been changed with no difference I'm doubting the reluctor wheel where the crankshaft had 58x and been changed to 24x.
Tried that with no luck :)
No codes or REP it feels like its rev limiting at 6300rpm so i checked everything with no luck.
Trans abuse is disables as you can see in the tune ^^
The plugs which im using is NGK tr7 gaped to .22 .
This problem happens even when its on low boost like 7 psi :)
I have set the abuse mode to 8,000rpm with no difference still the same?
The car has a set of ID 1050x injectors so theres plenty of room left and fuel pressure is good.
I will change it and try to see if it will solve the problem ill keep you updated
I have a 2003 Tahoe with built 6.0 and turbo kit im having a problem where the car pulls until it reaches 6300 rpm it feels like its misfiring with no pops or bang or its hitting a rev limiter but in...
The car is gen v which uses torque instead of airflow!
I have a 2014 gmc sierra with built 5.3 and btr stage 1 cam. The car struggles to startup but when i blip the throttle when the car surges it idles fine. Please if someone can help it will be...
The VVT Phase lockout means that it will limit the movment thus we have to disable it in the tune ?
Do I have to zero out the low/med/high desired angle under the variable camshaft tab?
and for the SOI table stock can be as a base tune to start with
I have a 2014 gmc sierra with turbo kit and I recently built the motor with piston/rods and installed btr stage 1 cam for it. My concern on how to tune these gen 5 motors with cam installed...
I mean by extracting the IAT is taking the two wires from mad sensor and install them in a new separate it sensor .
I don't use boost enrichment pe .
The map sensor is ZR1 map sensor .
The maf fail is set to 0 and dtc set to first error but the car doesnt start only after 10-20 cranks.
But when the code sets the car idles drive sweet like there is no issue.
hi everyone
I have 2003 chevy Tahoe recently I installed an ls2 turbo PTE7685 and on the charge pipe I had the MAF sensor installed, yesterday I extracted the IAT sensor from the MAF sensor and...
So whats the changes needed to be done in the tune ?
The cam has smooth idle
I have installed comp cam stage 3 blower cam and im having problems dialing the idle.
if anyone can chime in and help!!
Its a 2001 camaro for the o2 sensors.
ill check the pinout and will updates you guys if there is something weird or incorrect.