Search:

Like a compression test, the spread between them is more relevant than hitting a specific exact number. Lots of variables in an ohms test and it's unlikely all 8 in a set will have failed in exactly...

146103

But downstream O2 & cat codes have been turned off? Are they aftermarket/universal cats or the OE y-pipe?

146098

(that's not the correct layout that matches your VVE, but just a general 'how things work' deal)

It's always going to smell bad without cats on it. There are things you can do to improve...

I don't put a lot of stock in weird offsets between events in the logs, unfortunately. Sure would be nice if it didn't consistently try to fool you.

146096

Whether these things are a result of...

I think you are on the wrong track altogether, which can sometimes explain why you can't find info on others having done it before.

It always makes me happy when I make edits to someone's file and instead of using that file they try to copy over the changes I made into their original file, not knowing that there are things I can...

How would you put a stock OS back in it if you had one? Can't do it with HP Tuners, not on a Gen 4. Needs GM SPS.

If you don't have any idea what any of that means or why you can't do it, then...

There is no GM-format data for FAST injectors, they're made for aftermarket systems where none of that stuff matters.

Well that's not how you do that, use the one column from both tables that matches your base pressure (408kPa will be close enough for 58 PSI).

CMP counts did increment in the runs-on-starter-fluid log.

And figure out what's wrong with the MAP pinout, those are often swapped around too. Some of the swap harness companies don't realize there are multiple different pin arrangements for different...

OK, so how did this file get a 2-bar speed density OS applied? That's your problem. The new VE tables are filled with zeroes. The defaults for MAP linear/offset also get changed with the OS.

Depending on what components you re-used in this swap, man alive do you have a bunch of DTCs that need attention. EVAP? ABS? BCM? Cats & downstream O2s? There's also a theft deterrent DTC still...

Why does MAP never change from 59 kPa? Why 'OL - Fault'?

Up thru 2007 they all kept the same wording about loss of CMP behavior, 2008 it's strangely not mentioned one way or the other, then 2009 it changes to what's quoted up above about being able to run...

'72 Uncle Jessie truck ended but relisted, $2k
https://www.ebay.com/itm/256501825731

'63 Galaxie? Body looks solid enough. Scab some floor-like materials into it, two basic seats, drop in a real...

Log shows it in closed loop, the O2s are switching, and trims are working so I don't see how it would be possible for it to be 'using too much fuel'. Trims will bring it back to stoich, it can only...

Your tune file has all the DOD bullshit still turned on.

Does it look something like this?

146069

146068

E40 and earlier have this in the manual:


By 2009 that language is gone.


...meaning that unlike the older stuff the engine will continue to run if CKP is lost.

Wouldn't a msising CMP still leave it with only a 50/50 chance of guessing #1 TDC, and at least occasionally it would guess wrong and give a long crank or popping/banging and a no-start? Even if the...

...at which point if you don't have the tools & SPS subscription it's way cheaper to buy a used ECM of the correct service number pre-SPSed to a VIN you supply.

...and if doing that, there is no...

I assume you can only be asking that if you have not opened the file and looked at it, which seems like would be easier and waste less time than if I went through a whole sales pitch explaining its...