One thing thats been constant since I got everything back together has been the "Service Electronic Throttle Control" MIL. Not sure what thats from as it was working perfectly fine before the cam...
Type: Posts; User: nakedbee
One thing thats been constant since I got everything back together has been the "Service Electronic Throttle Control" MIL. Not sure what thats from as it was working perfectly fine before the cam...
Finally got around to a compression check, these numbers are cold BTW.
1 - 182.5
2 - 180
3 - 186
4 - 179
5 - 192.5
6 - 182
7 - 192.5
8 - 180
Cold start this AM added, not good wouldnt stay running at all but managed to keep it running around 1400rpm with throttle input. I figured I would have driveability issues but not to even run? When...
If it helps I will try and capture a log on a cold start so y'all can see exactly what its doing.
145218
Just got the BTR Truck Norris cam installed along with the Pushrods/springs/ whatever lock/limiter it comes with as well as an MDS delete with "hellcat" lifters. I also put some catless...
0x7E8: P0315 - Crankshaft Position System Variation Not Learned (Pending, Current, History)
0x7E8: P0443 - Evaporative Emission System Purge Control Valve Circuit (Pending, Current)
0x7E8: P0449 -...
Still having the same issues but I have verified that the CKP is indeed receiving and out putting the correct voltage. All grounds are accounted for, ECU is receiving all required B+ inputs. I...
Ok so apparently I did have all of those pins powered besides pin28 on J2. I had to pin out pin28 as in my print out from alldata it has the pin as not used. Anyway pinned that out and connected it...
Much thanks to EFIHARNESS for going out of your way to help, you definitely know your stuff :worship:
Ok I'll remove the power to that pin. I'm not sure what you mean by powertrain relay, the only relays I've wired that the ECU has any control over is the fuel pump and fans. And no I don't believe...
Long story short:
I have a Exocet (miata) with a LE5 swap attached to a Solstice 5 speed. I'm using the E67 ecu. I bypassed the starting circuit so it turns over but will not even try to fire. ...
Ok long story short I'm swapping a 98 4.3L engine out of an s10 into my 97 forwinns boat that had the Volvo Penta 4.3l engine yada yada anyway. I want to keep the EFI setup and pretty much swap over...