x2
Type: Posts; User: John Hall
x2
So 300 kpa would be 43.5 psi fuel pressure
thanks guys
I hope its ok that i post this..If you buy the deka 80 injectors do they come with the injector data or do you have to download it? I bought some off of Ebay and the seller said that they were deka...
Thanks
does the ses enabled need to be checked or unchecked
When running sd does the airflow vs frequency need to be set to zero?
thanks guys..I have made the changes and see how it goes
ok i had 200 linear and 10.33 offset i searched the part number on the map sensor and it said 200 linear and 8 offset..doesnt seem like much difference. is that enough to make it start and die
Ok so im new to all this but im trying really hard..I installed sd 2 bar and my tune. The car started and died and now it wont start. please can someone help me..7598775988
ok im good now lol..i went back to write entire and it worked...
ok i read vehicle saved file added 2 bar sd tried to write entire and it said failed..please tell me i didnt brick my pcm..im about to pull my hair out:banghead:please help
Thank man
ok i want to write my 3 bar tune but only have a 1 bar map sensor..im not going to be driving the car..only starting it and backing out of the garage..will doing the tune be ok until i get my 3 bar...
Thanks 5FDP..Yes it is a sloppy mechanics tune lol. Im just trying to get a decent tune so i can get it running. Im about to pull my hair out
P01 pcm
Im running a Th350 and trying to disable tm..I have found out how to do it but im not sure what to use for the ones that are to be maxed out. what do i set them to.
I will never figure this out lol
Thank you 5FDP
Ok i have a 3 bar sd tune that i want to use and i noticed the tune file was for a 4l80e trans..can i use this tune even though i have a th350 trans
Ok i have a 3 bar sd tune that i want to use and i noticed the tune file was for a 4l80e trans..can i use this tune even though i have a th350 trans
Kentucky here
Im trying to convert Map to read boost..I have read and watched some videos but i keep getting a brain fart and cant figure it out..Please excuse my ignorance..A couple videos say to open vcm scanner...
Thank you
I hope this is the right place to post this..I have a tune already in my pcm..if i want to do another tune can i write over that tune or do i have to write the stock tune back first sorry if this is...