Search:

its a 6L80E

I thank you for looking into it and giving me feedback!!

I will try to get those cylinder header temps this evening my gun was saying like 350 and 400 in that area so I know it was not correct, but they are shiny stainless steel and I think that is not...

I have 2 brand new Magnaflow cats. and no bad exhaust smell just all the hand prints and grease stuff burning in.
after market, have not installed post cat o2 sensors

146094
here is a longer log nothing interesting just ez drive to work in traffic
my temp gun was difficult to get a good reading on the stainless pipes but at idle after a drive the gun was...

I couldn't figure out how to delete the post so I was hoping posting entered in error the MODs would delete it

I appreciate the input, I will pull a longer log and use a laser temp gun tomorrow on my way back from work

just finished this L92 (6.2 from 08 escalade) with stock internals cold intake and 2.5" Y pipe with dual cats and single 3.5" exhaust with 14 inch magnaflow, swap into a jeep wrangler and got the...

entered in error

Uploaded the HPL file. I'm getting MIL codes now that I wasn't getting with another scanner. Looks like the problem is the throttle body, and possibly the pedal

Lol OK thanks, just to be clear I wasn't going to turn on any codes that were turned off or enable any that were disabled just change it from no light to first error so it would show a code if that's...

Omg you're right, thank you!

Can Admin move this to the Gen 4 section?

That could very possibly be, I'll go and turn all the no light settings to 1 error

Ikr, that's what's so puzzling here. Engine runs outstanding otherwise. Just when I blip the throttle pedal hard to "bump" the jeep over an obstacle. I'll try to get a data log today.

I checked and no codes were found,
Yes I believe pedal and Throttle body are orignal to the 08 Escalade

No codes that I can tell. I just set the MIL to 1 error on all parameters that were set to 2 errors. I will try to get a log tomorrow, when I tried today the program crashed. Should I try to...

I have a 2008 6.2 from a escalade in my 2005 jeep rock crawler, every time that I need to go WOT to get over a obstacle my engine goes into limp mode. the PCM was tuned before I got the vehicle and...