Those year of truck are common for can bus issues.
Start by checking can bus wiring near the terminating resistor at the back of the truck near spar tire. If you do a search on google of lml can...
Type: Posts; User: jakezed22
Those year of truck are common for can bus issues.
Start by checking can bus wiring near the terminating resistor at the back of the truck near spar tire. If you do a search on google of lml can...
I?m gonna convert my tractor to EFI. Firing order is 1-3-4-2. Same as cobalt or any other gem inline 4? I think. What would be your recomendation on the the best supported ecm for this project. ...
Can someone confirm if e86b is supported in tune translation?
Trying to convert bin e86b to hpt, site doesnt seem to work for me?
Is it supported i only see e86a on the list.
Thank you
Title says it, can I read and flash with the mpvi3 by itself without the lap top connected?
Just curious if its in the works or not?
Wait since when did hpt enable the dtc list again??
Is there any way i can make my fpcm dumb. As in so it doesnt factor in injector delta or anyting. I just want it to make 10 psi and thats it.
2014 camaro stock hardware.
I have my FPCM liscened and thats what im tuning to get where im at now.
Not finding lots of good info for tuning FPCM.
Using the factory FPCM and ecm from the gas just cause why not lol.
I ended up limiting the max duty cycle down to 20 percent tonight and that seems to be keeping it in check, Although the...
2015 is LML
Def is not used for Regen
After enough time has passed without a successful regen, the truck will limit/derate
Bump
Any advice for setting lower pressure, only need 10 psi.
My next thing im thinking is to lower minimum duty cyle for the pump (its set to 90% acroos the baord)
Ive searched and only...
Looking for help with user defined parameters
Not looking for just a hand out.
My email is [email protected]
Hey!
Ive modified every conceivable table i can find for fuel pressure and set them to 10 psi
When scanning i have desired 10 psi but injector delta reads 25 and actual also reads 25 :mad:
...
Heres one that i disabled maf on to have some fun.
Careful i could stall th eturbo with this tune, would be best to reenable maf before running.
Ill have to get a final version from my other...
Running very strong, ill try attached the latest revision i had of this tune.
in the end i was on par with a LML H and S tuned
What are you judging you mileage by?
I?ve played around a bit with one, did torque management and all the basics. I think most everything is supported. What specifics where you after?
Downloaded and tried to open the above file, every time i go to open it, VCM editor crashes.
Has anyone tried this yet? Looking for some feed back on what?s required to write?
ill double check what I have the codes set as, I'm thinking I habe them on no error report.
I'm using fuel trims for now, trying to get it right under 4000 rpm
79913
I'm having trouble tuning my VE table,
Gen 4 5.3
Manual Trans
I logged and did the multiply by percent a couple times, but it seems to be getting worse according to the log.
Take a look and...