Printable View
I was doing some experimenting and changed some of the prediction coefficients and now I would like to to change them back to stock (as seen in the screenshot), however, the OEM calibration exceeds HPT's range of +/-1000. Is this a defect on the HPT side? I am scared to click yes to the warning message.
Attachment 145518
Attachment 145519
I have to admit I would follow the instructions and contact support.
Yeah, they're bugs. Wind them out. Min: -3.4E+38 Max: 3.4E+38
CTRL+L, find one from before you made the change, right-click & Open in New Editor and save.
This happens in other tables as well, depending on year/platform.
Attachment 145534
yep, that one always confused me.Quote:
Originally Posted by blindsquirrel
Also some gen 3's will have 12xx in some max torque tables from the factory when the editor only allows 640.
At least I think I understand the reasoning behind exceeding the max on that one, it changes the shape leading up to/after the peak and the dwell time at 194F, even if the value the ECM uses never goes over 2.000.
Attachment 145571