Page 1 of 833 123451151101501 ... LastLast
Threads 1 to 20 of 16648

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 247,827
    TheMechanic
    06-06-2023 Go to last post

  1. 5.3 Swap Starts then Dies

    Started by angelm_ix, 1 Day Ago
    5 Attachment(s)
    • Replies: 14
    • Views: 161
    angelm_ix
    8 Minutes Ago Go to last post

  2. using a ton of fuel and exhaust is hotter than I think it should be

    Started by TjTodd, 45 Minutes Ago
    2 Attachment(s)
    • Replies: 1
    • Views: 29
    blindsquirrel
    10 Minutes Ago Go to last post

  3. Help dial in this tune please.

    Started by kendallkmw, 1 Hour Ago
    3 Attachment(s)
    • Replies: 1
    • Views: 27
    blindsquirrel
    28 Minutes Ago Go to last post

  4. turbo log maifold O2 settings

    Started by poulina, 3 Days Ago
    1 Attachment(s)
    • Replies: 2
    • Views: 78
    poulina
    52 Minutes Ago Go to last post

  5. "OL-Not Ready" with EQ Cmd 15.97. Why and from where...

    Started by S-351R, 03-06-2023
    3 Attachment(s)
    • Replies: 10
    • Views: 1,105
    C6_daily
    2 Hours Ago Go to last post

  6. 2007 silverado 5.3 FSCM

    Started by nickweidling, 2 Hours Ago
    • Replies: 0
    • Views: 29
    nickweidling
    2 Hours Ago Go to last post

  7. Ls3 Log e85 boost target AFR WOT

    Started by Chad1234hol, 3 Hours Ago
    • Replies: 0
    • Views: 29
    Chad1234hol
    3 Hours Ago Go to last post

  8. Heat Soaked Restart Issues

    Started by Cringer, 1 Week Ago
    3 Pages •
    1 2 3
    20 Attachment(s)
    • Replies: 58
    • Views: 1,942
    STAGEUP
    4 Hours Ago Go to last post

  9. (Almost) New to HP Tuners

    Started by Shroomun, 1 Day Ago
    • Replies: 4
    • Views: 120
    JayRolla
    5 Hours Ago Go to last post

  10. A few questions regarding swapping OS

    Started by Agtronic, 7 Hours Ago
    • Replies: 4
    • Views: 73
    blindsquirrel
    5 Hours Ago Go to last post

  11. ECM 14072 test for missfire

    Started by obthomas, 6 Hours Ago
    • Replies: 3
    • Views: 51
    gtstorey
    5 Hours Ago Go to last post

  12. What am I missing? Open Loop Delay?

    Started by CTSVNZ, 12 Hours Ago
    3 Attachment(s)
    • Replies: 8
    • Views: 159
    Alvin
    7 Hours Ago Go to last post

  13. Cammed Ve Ss Manual L98

    Started by troyjago, 1 Day Ago
    6 Attachment(s)
    • Replies: 7
    • Views: 151
    troyjago
    7 Hours Ago Go to last post

  14. Does 6l80 function safely with MAF tune only?

    Started by NastyLS3, 6 Days Ago
    • Replies: 9
    • Views: 396
    Alvin
    7 Hours Ago Go to last post

  15. Adjusting cooling fans to operate at highway speeds if needed?

    Started by [email protected], 08-05-2022
    • Replies: 19
    • Views: 2,055
    eficalibrator
    8 Hours Ago Go to last post

  16. Operating OS's 1250216 & 1250219 compatibility

    Started by Guy With A Chevy, 1 Day Ago
    1 Attachment(s)
    • Replies: 10
    • Views: 266
    gtstorey
    8 Hours Ago Go to last post

  17. Help Tuning VVE / Start and run, but not idle

    Started by Loose_Screws, 3 Days Ago
    3 Pages •
    1 2 3
    36 Attachment(s)
    • Replies: 48
    • Views: 866
    LS ROB
    20 Hours Ago Go to last post

  18. Tuning MAF and VVE at the Same Time

    Started by Cringer, 04-04-2023
    12 Pages •
    1 2 3 ... 12
    30 Attachment(s)
    • Replies: 225
    • Views: 38,051
    DobermanRacing
    23 Hours Ago Go to last post

  19. Post Bad E38 ECM?

    Started by Richard F., 1 Day Ago
    4 Attachment(s)
    • Replies: 14
    • Views: 234
    TheMechanic
    1 Day Ago Go to last post

  20. Fuel trims sporatic randomly.

    Started by 8aHemi, 3 Days Ago
    5 Attachment(s)
    • Replies: 14
    • Views: 418
    edcmat-l1
    1 Day Ago Go to last post
Page 1 of 833 123451151101501 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.