Page 1 of 833 123451151101501 ... LastLast
Threads 1 to 20 of 16650

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 247,917
    TheMechanic
    06-06-2023 Go to last post

  1. E38 injector flow rate v voltage doesnt work?

    Started by 8aHemi, 4 Hours Ago
    • Replies: 1
    • Views: 28
    blindsquirrel
    11 Minutes Ago Go to last post

  2. Help dial in this tune please.

    Started by kendallkmw, 14 Hours Ago
    6 Attachment(s)
    • Replies: 3
    • Views: 114
    blindsquirrel
    14 Minutes Ago Go to last post

  3. 5.3 Swap Starts then Dies

    Started by angelm_ix, 1 Day Ago
    2 Pages •
    1 2
    8 Attachment(s)
    • Replies: 32
    • Views: 361
    edcmat-l1
    19 Minutes Ago Go to last post

  4. What spark plugs for 416 stroker on e85?

    Started by 02Ls1, 05-16-2018
    • Replies: 3
    • Views: 1,918
    BULLETPROOF
    6 Hours Ago Go to last post

  5. Fueling issues with vacuum ref fuel system without FPCM

    Started by ekdream, 11 Hours Ago
    1 Attachment(s)
    • Replies: 2
    • Views: 104
    ekdream
    8 Hours Ago Go to last post

  6. Ls3 Log e85 boost target AFR WOT

    Started by Chad1234hol, 16 Hours Ago
    • Replies: 1
    • Views: 60
    Lakegoat
    9 Hours Ago Go to last post

  7. Cammed Ve Ss Manual L98

    Started by troyjago, 2 Days Ago
    6 Attachment(s)
    • Replies: 8
    • Views: 179
    troyjago
    10 Hours Ago Go to last post

  8. using a ton of fuel and exhaust is hotter than I think it should be

    Started by TjTodd, 13 Hours Ago
    2 Attachment(s)
    • Replies: 3
    • Views: 89
    TjTodd
    11 Hours Ago Go to last post

  9. (Almost) New to HP Tuners

    Started by Shroomun, 1 Day Ago
    • Replies: 5
    • Views: 146
    Tfoggy
    12 Hours Ago Go to last post

  10. turbo log maifold O2 settings

    Started by poulina, 3 Days Ago
    1 Attachment(s)
    • Replies: 2
    • Views: 95
    poulina
    13 Hours Ago Go to last post

  11. "OL-Not Ready" with EQ Cmd 15.97. Why and from where...

    Started by S-351R, 03-06-2023
    3 Attachment(s)
    • Replies: 10
    • Views: 1,128
    C6_daily
    15 Hours Ago Go to last post

  12. 2007 silverado 5.3 FSCM

    Started by nickweidling, 15 Hours Ago
    • Replies: 0
    • Views: 62
    nickweidling
    15 Hours Ago Go to last post

  13. Heat Soaked Restart Issues

    Started by Cringer, 1 Week Ago
    3 Pages •
    1 2 3
    20 Attachment(s)
    • Replies: 58
    • Views: 1,985
    STAGEUP
    18 Hours Ago Go to last post

  14. A few questions regarding swapping OS

    Started by Agtronic, 20 Hours Ago
    • Replies: 4
    • Views: 93
    blindsquirrel
    18 Hours Ago Go to last post

  15. ECM 14072 test for missfire

    Started by obthomas, 19 Hours Ago
    • Replies: 3
    • Views: 61
    gtstorey
    19 Hours Ago Go to last post

  16. What am I missing? Open Loop Delay?

    Started by CTSVNZ, 1 Day Ago
    3 Attachment(s)
    • Replies: 8
    • Views: 186
    Alvin
    20 Hours Ago Go to last post

  17. Does 6l80 function safely with MAF tune only?

    Started by NastyLS3, 6 Days Ago
    • Replies: 9
    • Views: 403
    Alvin
    20 Hours Ago Go to last post

  18. Adjusting cooling fans to operate at highway speeds if needed?

    Started by [email protected], 08-05-2022
    • Replies: 19
    • Views: 2,065
    eficalibrator
    21 Hours Ago Go to last post

  19. Operating OS's 1250216 & 1250219 compatibility

    Started by Guy With A Chevy, 2 Days Ago
    1 Attachment(s)
    • Replies: 10
    • Views: 268
    gtstorey
    21 Hours Ago Go to last post

  20. Help Tuning VVE / Start and run, but not idle

    Started by Loose_Screws, 4 Days Ago
    3 Pages •
    1 2 3
    36 Attachment(s)
    • Replies: 48
    • Views: 878
    LS ROB
    1 Day Ago Go to last post
Page 1 of 833 123451151101501 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.